Примечания к выпуску для Cisco Cisco 2106 Wireless LAN Controller

Do not upgrade to controller software release 4.2.205.0 if you have mesh access points in your network. 
If your network uses mesh access points, use only mesh-specific releases. These releases are labeled 
MESH in the Software Center.

Cisco WCS software release 4.2.128.0 may be used to manage both mesh and non-mesh controllers 
(such as controllers running software release 4.2.205.0 and 4.1.192.35M). You do not need different 
instances of WCS to manage mesh and non-mesh controllers.

The controller GUI requires the following operating system and web browser:

Windows XP SP1 or higher or Windows 2000 SP4 or higher

Internet Explorer 6.0 SP1 or higher

Internet Explorer 6.0 SP1 or higher is the only browser supported for accessing the 
controller GUI and for using web authentication.

Software is factory installed on your controller and automatically downloaded to the access points after 
a release upgrade and whenever an access point joins a controller. As new releases become available for 
the controllers and their access points, consider upgrading.

The Cisco WiSM requires software release SWISMK9-32 or later. The Supervisor 720 12.2(18)SXF2 
supports the Cisco WiSM software release 3.2.78.4 or later, and the Supervisor 720 12.2(18)SXF5 
(Cisco IOS Software Modularity) supports the Cisco WiSM software release 4.0.155.5 (with Cisco IOS 
Software Modularity).

To use the Cisco WiSM in the Cisco 7609 and 7613 Series Routers, the routers must be running Cisco 
IOS Release 12.2(18)SXF5 or later.

The Cisco Wireless LAN Controller Network Module is supported on Cisco 28/37/38xx Series 
Integrated Services Routers running Cisco IOS Release 12.4(11)T2, 12.4(11)T3, and 12.5.

When you use the controller in the Catalyst 3750G Wireless LAN Controller Switch, the 3750 should 
not run Cisco IOS Releases 12.2(44)SE2 and 12.2(46)SE due to defect CSCsu02630.