Примечания к выпуску для Cisco Cisco 2106 Wireless LAN Controller

All of the channels in the W56 band require dynamic frequency selection (DFS). In Japan, the W56 
band is subject to Japan’s DFS regulations. Currently, only the new 1130 and 1240 series access 
point SKUs (with the -Q product code) support this requirement: AIR-LAP1132AG-Q-K9 and 
AIR-LAP1242AG-Q-K9.

To set up a network consisting of only -P and -Q access points, configure the country code to J2. To 
set up a network consisting of -P, -Q, and -U access points, configure the country code to J3.

Additional country support—Country codes have been added for these additional countries 
supported by the controller: Bahrain (BH), Costa Rica (CR), Dominican Republic (DO), Ecuador 
(EC), Kazahkstan (KZ), Kuwait (KW), Oman (OM), Pakistan (PK), Paraguay (PY), Puerto Rico 
(PR), Vietnam (VN).

For a complete list of country codes supported per product, refer to 

These additional changes are applicable to controller software release 5.0.148.0:

You cannot configure the LWAPP mode from the controller configuration wizard, GUI, or CLI. 
Controller software release 5.0.148.0 supports only Layer 3 LWAPP mode.

The show msglog CLI command will be discontinued. Please use the show logging command 
instead.

The controller leverages actual PHY and Low Layer MAC measurements by the access point and 
client to better estimate Rx, Tx, and CCA loads.

New messages appear on the controller CLI when you make a configuration change that requires a 
reboot. Here is an example: “Please save the configuration and reset the system (“reset system”) for 
the change to take effect.”

This section contains important information to keep in mind when installing controllers and access 
points.

136

5680

17

15

140

5700

17

15