Руководство По Устранению Ошибки для Cisco Cisco Flex 7510 Wireless Controller
Verify
You can use the show capwap ip config command in enable mode to view the CAPWAP configuration
present on the LAP.
present on the LAP.
Here is an example:
AP1240#show capwap ip config
LWAPP Static IP Configuration
IP Address 10.77.244.199
IP netmask 255.255.255.224
Default Gateway 10.77.244.220
Primary Controller 172.16.1.50
Troubleshoot
You can use this debug command on the LAP with a console port to troubleshoot the static configuration:
debug ip udp
Note: If the AP has no console port, it is necessary to take a wired sniffer trace of the port that the
LAP is plugged into to see what packets are being received by and transmitted to the LAP.
LAP is plugged into to see what packets are being received by and transmitted to the LAP.
•
You can use these debug commands in order to monitor the discovery process through the WLC CLI.
debug capwap events enable
•
debug capwap packet enable
•
Related Information
Cisco Wireless LAN Controller Configuration Guide, Release 7.0.116.0
•
DHCP OPTION 43 for Lightweight Cisco Aironet Access Points Configuration Example
•
Wireless LAN Controller and Lightweight Access Point Basic Configuration Example
•
Technical Support & Documentation − Cisco Systems
•
Contacts & Feedback | Help | Site Map
© 2014 − 2015 Cisco Systems, Inc. All rights reserved. Terms & Conditions | Privacy Statement | Cookie Policy | Trademarks of
Cisco Systems, Inc.
© 2014 − 2015 Cisco Systems, Inc. All rights reserved. Terms & Conditions | Privacy Statement | Cookie Policy | Trademarks of
Cisco Systems, Inc.
Updated: Nov 30, 2011
Document ID: 99763