Примечания к выпуску для Cisco Cisco 2000 Series Wireless LAN Controller
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
6
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 3.2.193.5
OL-xxxxx-xx
Installation Notes
ap2 AP1030 00:0b:85:5b:8e:c2 WCN093802CJ Undef.
Begin to migrate Access Points from "J"(J52) to "U"(W52). Are you sure? (y/n) y
Step 5
Wait for completion, then use "show ap migrate" to verify migration for all APs
Enter Y when
prompted to confirm your decision to migrate.
Step 6
Wait for all access points to reboot and rejoin the controller. This process may take up to 15 minutes.
Step 7
Enter this command to verify migration for all access points:
show ap migrate
Information similar to the following appears:
(Controller) >show ap migrate
AP Name AP Model Ethernet MAC Serial Num. RegDom
------------------ ------------------- ----------------- ----------- ------
ap1 AP1030 00:0b:85:5b:8e:c0 WCN093800CJ -U
ap2 AP1030 00:0b:85:5b:8e:c2 WCN093802CJ -U
ap3 AP1030 00:0b:85:5b:8e:c4 WCN093804CJ -U
ap4 AP1030 00:0b:85:5b:8e:c6 WCN093806CJ -P
Step 8
Enter these commands to re-enable the 802.11a and 802.11b/g networks:
config 802.11a enable network
config 802.11b enable network
Step 9
Report the result of your migration to your manufacturer.
Installation Notes
This section contains important information to keep in mind when installing your controllers and access
points.
points.
Warnings
Warning
This warning means danger. You are in a situation that could cause bodily injury. Before you work on
any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents.
any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Do not locate any antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing antennas, take extreme care not
to come in contact with such circuits, as they may cause serious injury or death. For proper
installation and grounding of the antenna, refer to national and local codes (e.g. U.S.: NFPA70,
National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).
where it can come into contact with such circuits. When installing antennas, take extreme care not
to come in contact with such circuits, as they may cause serious injury or death. For proper
installation and grounding of the antenna, refer to national and local codes (e.g. U.S.: NFPA70,
National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).