Технические ссылки для Cisco Cisco 5760 Wireless LAN Controller
ap capwap multicast
To configure the multicast address used by all access points to receive multicast traffic when multicast
forwarding is enabled and to configure the outer Quality of Service (QoS) level of those multicast packets
sent to the access points, use the ap capwap multicast command.
forwarding is enabled and to configure the outer Quality of Service (QoS) level of those multicast packets
sent to the access points, use the ap capwap multicast command.
ap capwap multicast {multicast-ip-address| service-policy output pollicymap-name}
Syntax Description
Multicast IP address.
multicast-ip-address
Specifies the tunnel QoS policy for multicast access points.
service-policy
Assigns a policy map name to the output.
output
Service policy map name.
policymap-name
Command Default
None
Command Modes
Global configuration
Command History
Modification
Release
This command was introduced.
Cisco IOS XE 3.2SE
Examples
This example shows how to configure a multicast address used by all access points to receive multicast traffic
when multicast forwarding is enabled:
when multicast forwarding is enabled:
Controller(config)#
ap capwap multicast 239.2.2.2
This example shows how to configure a tunnel multicast QoS service policy for multicast access points:
Controller(config)#
ap capwap multicast service-policy output tunnmulpolicy
Consolidated Platform Command Reference, Cisco IOS XE Release 3SE (Cisco WLC 5700 Series)
600
OL-29471-01
ap capwap multicast