Технические ссылки для Cisco Cisco 5760 Wireless LAN Controller
nmsp notification interval
To modify the Network Mobility Services Protocol (NMSP) notification interval value on the controller to
address latency in the network, use the nmsp notification interval command.
address latency in the network, use the nmsp notification interval command.
nmsp notification interval {attachment| location| rssi {clients| rfid| rogues {ap| client}}} interval
Syntax Description
Specifies the time used to aggregate attachment information.
attachment
Specifies the time used to aggregate location information.
location
Sets the RSSI measurement interval.
rssi
Modifies the interval for clients.
clients
Modifies the interval for active radio frequency identification (RFID) tags.
rfid
Modifies the interval for rogue access points and rogue clients.
rogues
Specifies measurement interval for rogue APs.
ap
Specifies measurement interval for rogue clients.
client
Time interval. The range is from 1 to 30 seconds.
The default time interval is 2 seconds for clients, RFID tags, and rogue APs and
clients. The default time interval is 30 seconds for attachment and location.
clients. The default time interval is 30 seconds for attachment and location.
interval
Command Default
None
Command Modes
Global configuration
Command History
Modification
Release
This command was introduced.
Cisco IOS XE 3.2SE
Examples
This example shows how to modify the NMSP notification interval for the active RFID tags to 25 seconds:
Controller#
configure terminal
Controller(config)#
nmsp notification-interval measurement rfid 25
Controller(config)#
end
Consolidated Platform Command Reference, Cisco IOS XE Release 3SE (Cisco WLC 5700 Series)
62
OL-29471-01
nmsp notification interval