Примечания к выпуску для Cisco Cisco 4402 Wireless LAN Controller
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
10
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 3.2.210.0
OL-xxxxx-xx
Important Notes
Using the CLI to Change the SNMP v3 User Default Values
Follow these steps to change the SNMP v3 user default values through the controller CLI.
Step 1
To see the current list of SNMP v3 users for this controller, enter this command:
show snmpv3user
Step 2
If “default” appears in the SNMP v3 User Name column, enter this command to delete this user:
config snmp v3user delete username
The username parameter is the SNMP v3 username (in this case, “default”).
Step 3
To create a new SNMP v3 user, enter this command:
config snmp v3user create username {ro | rw} {none | hmacmd5 | hmacsha} {none | des}
auth_password privacy_password
auth_password privacy_password
where
•
username is the SNMP v3 username,
•
ro is read-only mode and rw is read/write mode,
•
none, hmacmd5, and hmacsha are the authentication protocol options,
•
none and des are the privacy protocol options,
•
auth_password is the authentication password, and
•
privacy_password is the privacy password.
Do not enter “default” for the username and password parameters.
Step 4
To save your changes, enter save config.
FIPS 140-2
The Cisco 4400 Series Controllers are on the NIST FIPS 140-2 Pre-Validation List.
L2TP Not Supported
Software release 3.2.210.0 does not support L2TP. If you upgrade to this release from a previous release
that supported L2TP, any WLANs that are configured for that feature become disabled. If you want to
use L2TP you must use a version of controller software prior to 3.2 or wait for the next 3.2 release.
that supported L2TP, any WLANs that are configured for that feature become disabled. If you want to
use L2TP you must use a version of controller software prior to 3.2 or wait for the next 3.2 release.
Controllers Must Run Release 3.2.116.21 or Later to Support -P Regulatory
Domain
Domain
To support access points configured for use in Japan, you must upgrade the controller software to release
3.2.116.21 or later. Earlier releases do not support access points configured for use in Japan (regulatory
domain -P).
3.2.116.21 or later. Earlier releases do not support access points configured for use in Japan (regulatory
domain -P).