Технические ссылки для Cisco Cisco 5520 Wireless Controller
Over-riding AP Group Ethernet LAN Port Settings
One can configure Ethernet LAN ports settings on the AP group and these would apply to all the AIR-AP18101W Access Points.
To override this setting at individual AP level, follow the steps below:
To override this setting at individual AP level, follow the steps below:
Procedure
Step 1
On the WLC UI, Navigate to Wireless > Access Points > All APs. Select the AIR-AP1810W Access and go to the
Interfaces.
Interfaces.
Step 2
Click on the LAN Override check box. You can Enable/Disable LAN ports and POE for LAN1. Click on the Apply
button.
button.
Overriding LAN port settings will only apply to this AP and not the remaining APs in the AP Group. Overriding
of RLAN is not supported at AP level.
of RLAN is not supported at AP level.
Note
Configuring AIR-AP1810W (Wall Plate) to OfficeExtend AP
One can assemble and configure an AIR-AP1810W to operate as an OfficeExtend Access Point similar to the dedicated AIR-OEAP1810.
To assemble the AIR-AP10810W and use it as an OfficeExtend Access point, the following accessories can be ordered:
1
AIR-OEAP1810-CRD (Cradle Kit)–The Cradle Kit is sold separately and includes the RJ-45 Jumper cable, back cover for the
Access Point and the Cradle for seating the Access Point.
Access Point and the Cradle for seating the Access Point.
19