Примечания к выпуску для Cisco Cisco 4404 Wireless LAN Controller

CSCsh55789—The controller may experience communication problems that prevent access points 
from joining the controller. In this case, the following messages appear:

Msg 'Set Default Gateway' of System Table failed, Id = 0x008d2fa2

Msg 'Port HW Stats get' of Port Mgmt failed, Id = 0x00692fac erro

Msg 'Port SW Stats get' of Port Mgmt failed, Id = 0x005f0ac3 erro

Workaround: None at this time.

CSCsh58395—After web authentication completes successfully, a gray web page appears with the 
following text: “Web Authentication.” The web browser appears to be loading a page but never does. 
The original URL destination (such as http://www.cisco.com) never loads.

Workaround: Follow these steps:

Turn off the radio on the wireless client.

Remove the client entry from the controller.

Turn on the radio on the wireless client. 

Re-associate and re-authenticate the client to the WLAN.

CSCsh67667—If you try to set an invalid physical port number for the management interface, an 
error message appears indicating that the requested port is not available. However, the controller 
accepts the invalid physical port number.

Workaround: None at this time.

CSCsh67699—If you try to set an invalid physical port number of 25 or less for the management 
interface, an error message appears indicating that the configuration cannot be set. However, the 
controller accepts the invalid physical port number.

Workaround: None at this time.

CSCsh77184—If you disable more than four of the data rates on the 802.11a (or 802.11b/g) Global 
Parameters page, the supported rates do not exceed 24 Mbps.

Workaround: Set the Radio Policy field to All or 802.11b/g only on the WLANs > Edit page.

CSCsh90756—The show run-config command sometimes enters a loop, continually displaying the 
“--More-- or (q)uit--” message.

Workaround: None at this time.