Руководство По Установке для Cisco Cisco Email Security Appliance C190
10
10
Log In to the Appliance
You can log in to the Cisco C690 appliance using one of two
interfaces: the web-based interface or the command-line
interface.
interfaces: the web-based interface or the command-line
interface.
Web-Based Interface
Step 1
For web browser access via the Ethernet port (see the
), go to the
appliance’s management interface by entering the
following URL in a web browser:
following URL in a web browser:
http://192.168.42.42
Step 2
Log in with the following credentials:
•
Username: admin
•
Password: ironport
Command-Line Interface
Step 1
Access the command-line interface locally or remotely:
•
To access the CLI locally, set up a terminal to
connect to the serial port using 9600 bits, 8 bits, no
parity, 1 stop bit (9600, 8, N, 1) and flow control
set to Hardware. To physically connect the
terminal, see the
connect to the serial port using 9600 bits, 8 bits, no
parity, 1 stop bit (9600, 8, N, 1) and flow control
set to Hardware. To physically connect the
terminal, see the
•
To access the CLI remotely, initiate an SSH session
to the IP address 192.168.42.42.
to the IP address 192.168.42.42.
Step 2
Log in as admin with the password ironport.
Step 3
At the prompt, run the systemsetup command.