Руководство По Проектированию для Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point

Starting from release 5.2, mesh features within the controller’s boot configuration file are saved in an 
XML file in ASCII format. The XML configuration file is saved in the flash memory of the controller.

The current release does not support binary configuration files; however, configuration files are in the 
binary state immediately after an upgrade from a mesh release to controller software release 7.0. After 
reset, the XML configuration file is selected.

Do not edit the XML file. Downloading a modified configuration file onto a controller causes a cyclic 
redundancy check (CRC) error on boot and the configuration is reset to the default values.

You can easily read and modify the XML configuration file by converting it to CLI format. To convert 
from XML to CLI format, upload the configuration file to a TFTP or an FTP server. The controller 
initiates the conversion from XML to CLI during the upload.

Once on the server, you can read or edit the configuration file in CLI format. Then, you can download 
the file back to the controller. The controller converts the configuration file back to XML format, saves 
it to flash memory, and reboots using the new configuration.

The controller does not support uploading and downloading of port configuration CLI commands. If you 
want to configure the controller ports, enter the relevant commands summarized below:

The commands listed below are manually entered after the software upgrade to release 7.0.

config port linktrap {port | all} {enable | disable}–Enables or disables the up and down link traps 
for a specific controller port or for all ports.

config port adminmode {port | all} {enable | disable}–Enables or disables the administrative 
mode for a specific controller port or for all ports.

config port multicast appliance port {enable | disable}–Enables or disables the multicast 
appliance service for a specific controller port.

config port power {port | all} {enable | disable}–Enables or disables power over Ethernet (PoE) 
for a specific controller port or for all ports.

CLI commands with known keywords and proper syntax are converted to XML while improper CLI 
commands are ignored and saved to flash memory. Any field with an invalid value is filtered out and set 
to a default value by the XML validation engine.Validation occurs during bootup.

To see any ignored commands or invalid configuration values, enter the following command:

You can only execute this command before either the clear config or save config command. If 
the downloaded configuration contains a large number of invalid CLI commands, you might 
want to upload the invalid configuration to the TFTP or FTP server for analysis.