Release Note для Cisco Cisco TelePresence MX700
Introduction software version TC5.1.13
Cisco TelePresence System C/EX/SX/MX Series Software Release Notes
Page 11 of 194
Introduction software version TC5.1.13
This release note describes the features and capabilities included in the Cisco TelePresence System
C/MX/SX/EX series codec software version TC5.1.13 released on October 20
C/MX/SX/EX series codec software version TC5.1.13 released on October 20
th
2014.
Note: Please read the known limitations section if you use TMS to upgrade your system from any
release prior to TC4.0.0.
release prior to TC4.0.0.
From TC5.0.0 the C/EX/MX series supports provisioning and basic call functionality with
Cisco Unified Communications Manager (CUCM) version 8.6 and above. It also supports
Cisco Discovery Protocol (CDP) for easy deployment in CUCM environments. When
provisioning mode is set to CUCM the system will try to use Voice VLAN if available in your
network. With other provisioning modes, it will try to use Data VLAN.
Please be aware that in future releases Voice VLAN will be set to ‘Auto’ as per Cisco
best practice. If you are using Cisco switches, you need to prepare your network so
that network services (VCS, TMS, etc.) are reachable from your Voice VLAN.
best practice. If you are using Cisco switches, you need to prepare your network so
that network services (VCS, TMS, etc.) are reachable from your Voice VLAN.
Replacing a directly connected (EX series or MX series) or a Touch panel connected to
Ethernet port 2 (C40, C60 and C90) without restarting the system will leave the Touch panel
in an unusable state. A spinning “Connecting” wheel will be displayed, and after
approximately 2 minutes a manual pairing dialog will appear.
To replace the Touch panel successfully: Power off the system. Swap the Touch panels.
Power on the system. The Touch panel will come up, and if necessary, download software
from the system it is connected to. CDETS id: CSCud33527
Ethernet port 2 (C40, C60 and C90) without restarting the system will leave the Touch panel
in an unusable state. A spinning “Connecting” wheel will be displayed, and after
approximately 2 minutes a manual pairing dialog will appear.
To replace the Touch panel successfully: Power off the system. Swap the Touch panels.
Power on the system. The Touch panel will come up, and if necessary, download software
from the system it is connected to. CDETS id: CSCud33527
Hardware compatibility
Due to replacement of hardware components, there are some constraints on running older software
on newly manufactured endpoints. This is due to end-of-life of some components and introduction of
new components that require support in the software. Executing the API xcommand xstat
SystemUnit Hardware Module CompatibilityLevel will reveal if there are any constraints on the
system. For a detailed list of compatibility levels and software constraints for the Cisco TelePresence
systems, please see the two appendices in the end of this document:
on newly manufactured endpoints. This is due to end-of-life of some components and introduction of
new components that require support in the software. Executing the API xcommand xstat
SystemUnit Hardware Module CompatibilityLevel will reveal if there are any constraints on the
system. For a detailed list of compatibility levels and software constraints for the Cisco TelePresence
systems, please see the two appendices in the end of this document:
- HW dependencies – Compatibility Levels Cisco TelePresence Systems
- HW dependencies – Compatibility Levels Cisco TelePresence Touch 8
From TC5.1.3 onward, a lock prevents the system or Touch 8 from downgrading to an unsupported
version.
version.