Листовка для Cisco Cisco TelePresence MX700
Auto-registration of the endpoint
Only applicable when the CUCM is not set to mixed mode.
Configuration of the CUCM for auto-registration of the
endpoint is described on this page.
Auto-registration of the TelePresence endpoint is not
possible when the Cisco Unified CM is set to mixed
mode (cluster security mode).
Use the search options available on the page, or leave the
search field blank and press Find to list the available Cisco
Unified CMs.
• Choose the one you would like to configure; this will take
you to the Cisco Unified CM Configuration page.
Enable auto-registration
Navigate to the Auto-registration Information section.
Starting Directory Number: Enter the lowest number in
the range of directory numbers.
Ending Directory Number: Enter the highest number in the
range of directory numbers.
Auto-registration Disabled on this Cisco Unified
Communications Manager: Uncheck the checkbox to
enable auto-registration.
When done click
Save and Apply Config.
Navigate to the
Auto-registration Information section.
Navigate to: System > Cisco Unified CM.
Click
Find and choose the CUCM from the list.
Cisco TelePresence Endpoints and Cisco Unified Communications Manager
Quick Reference Guide
D14996.06 Administering TC6.3 Endpoints on CUCM 9.1.2, OCTOBER 2013.
www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved.
29
Mandatory Optional
Contents
Introduction
CUCM configuration
Endpoint configuration
About passwords
Appendices
CUCM configuration