Примечания к выпуску для Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch
12
Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.4.0
Release Notes
•
When storm control is enabled on a port, and the port speed is reduced to a
lower speed, storm control is displayed as disabled, on the web GUI.
(CQ149542, CSCui59739)
lower speed, storm control is displayed as disabled, on the web GUI.
(CQ149542, CSCui59739)
•
Although users can bind a non-existent ACL and a key chain to a Layer3
interface via the web GUI, they cannot edit or delete the entry. (CQ148424,
CSCuh56676)
interface via the web GUI, they cannot edit or delete the entry. (CQ148424,
CSCuh56676)
•
Enable password authentication does not work with ACS 5.4 TACACS+.
(CQ146266, CSCue93645)
(CQ146266, CSCue93645)
•
SG500XG-8F8T and SG500X can not be stacked together if using 1G SFP
stack cable, and if the stack ports are configured at AUTO speed.
(CQ149496, CSCui54965)
stack cable, and if the stack ports are configured at AUTO speed.
(CQ149496, CSCui54965)
•
On SG500XG-8F8T, if the user enables Short Reach and Green-Ethernet,
the Short Reach operation always remains off. (CQ147929, CSCuj46182)
the Short Reach operation always remains off. (CQ147929, CSCuj46182)
•
When two features are enabled on the same port, IP ACL blocks DHCP, DNS
or HTTP traffic and web-based authentication does not work. (CQ148890)
or HTTP traffic and web-based authentication does not work. (CQ148890)
•
It is impossible to configure more than 255 multicast groups on an Sx500
switch in Router Mode. The stated limit in the documentation is 1k multicast
groups. (CQ143282)
switch in Router Mode. The stated limit in the documentation is 1k multicast
groups. (CQ143282)
•
When configuring a manual IPv6 tunnel with EUI-64 format, the Global IPv6
address is not created. (CQ140132)
address is not created. (CQ140132)
•
You cannot configure ipv6 tunnel parameters if you previously did not
define the mode type. (CQ140919)
define the mode type. (CQ140919)
•
On the SX500 and SG500X switches, when users modify the unit ID, and
force master selection at the same time, the stack master shuts down.
(CQ150148, CSCuj38655)
force master selection at the same time, the stack master shuts down.
(CQ150148, CSCuj38655)
Limitations and Restrictions
The following caveats are acknowledged in firmware version
1.4.0.x:
1.4.0.x:
Problem:
When Sx500 devices are connected in a ring topology, the IP mroute
entry, learned through IGMP proxy, flaps. (CSCun67979)
Solution:
There is no workaround.