Примечания к выпуску для Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch

Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.3.0.62

7

•

Added support for RMON History, Events and Alarms for the 200 Series 
Switches.

•

Added Basic Hybrid and Advanced Hybrid modes for stacking. Increased 
the number of units in a Hybrid stack up to 8.

•

Added Unicast SNTP Server time synchronization.

•

Added the SCP option for the 200 Series Switches.

•

Reorganized the web-based administration by adding the System Object 
ID and SNMP Service to the Sx300 System Summary page in System 
Information. Removed the TCAM Allocation page and added the Router 
Resources page.

•

Added several IPv6 improvements. Added IPv6 Support for TACAS+, Telnet 
server, DHCPv6 Client, and DHCPv6 Relay.

•

Added support for SNMP and SSH Client to the 200 Series Switches.

•

Updated DSCP to Queue to 8 queues where relevant.

•

Added DHCPv4 Server

•

Static IPv6 Routing on the 500 series has been added.

•

Increased the number of LAG interface from 8 to 32 on 500 Series.

•

Firefox 4 to 10, Internet Explorer 7 to 9, Safari Browser 5-6, and Chrome 
Browser 14-15 are supported.

•

The system cannot access Management IP successfully after the switch is 
reset to default, and the IP address is set as static 192.168.1.254. If any other 
static IP addess is confirgured, there is no problem. (CQ147364)

•

The firmware MD5 Checksum is missing while executing “show version 
md5” command through CLI. (CQ147303)

•

In GUI, if two same ACE are created on one ACL, for example: ip access-list 
permit any, then deleting one of the ACE will cause the DUT to crash. This