Примечания к выпуску для Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch
Release Notes for Cisco Small Business 200E Series Advanced Smart Switches Release 1.0.6.2
3
Release Notes
Problem:
Selected special characters such as: ",',%,!,?,×,÷ are not allowed in any
GUI/CLI user-input fields (e.g. password, vlan name, snmp community fields,
hostname, etc.). In addition, the whitespace/blank is not supported only in the
Password field.
hostname, etc.). In addition, the whitespace/blank is not supported only in the
Password field.
Solution:
It is possible to utilize a subset : ",',%,!,? via CLI configurations, however,
it is recommended that they should not be used due to possible compatibility
issues. If a user had provisioned this subset of characters in previous load via CLI,
such as the password, then the user can continue to access via GUI using these
special characters.
issues. If a user had provisioned this subset of characters in previous load via CLI,
such as the password, then the user can continue to access via GUI using these
special characters.
Problem:
When using Internet Explorer version 6 with the Japanese language, the
Filter label is displayed vertically.
Solution:
Use Internet Explorer version 8 or a different browser.
802.3af Considerations
The following information supersedes any that is found in the Administration Guide
and on-line help:
and on-line help:
•
802.3af 4point - Resistive signature devices detected with the first
algorithm that corresponds to the original IEEE 802.3af-2003 PoE standard
that provides up to 15.4 W of DC power (minimum 44 V DC and 350 mA) to
each device. This mode also supports failover by auto-detecting legacy
powered devices. This detection type includes extra detection and
resistance measurement of connected device in an attempt to eliminate
unwanted noise. This is the recommended setting.
algorithm that corresponds to the original IEEE 802.3af-2003 PoE standard
that provides up to 15.4 W of DC power (minimum 44 V DC and 350 mA) to
each device. This mode also supports failover by auto-detecting legacy
powered devices. This detection type includes extra detection and
resistance measurement of connected device in an attempt to eliminate
unwanted noise. This is the recommended setting.
•
802.3af 2point - Resistive signature devices detected with the first
algorithm that correspond to the original IEEE 802.3af-2003 PoE standard
that provides up to 15.4 W of DC power (minimum 44 V DC and 350 mA) to
each device. This mode also supports failover by auto-detecting legacy
powered devices. This selection is not recommended unless the device
you are using explicitly recommends this setting.
algorithm that correspond to the original IEEE 802.3af-2003 PoE standard
that provides up to 15.4 W of DC power (minimum 44 V DC and 350 mA) to
each device. This mode also supports failover by auto-detecting legacy
powered devices. This selection is not recommended unless the device
you are using explicitly recommends this setting.
Major Changes and Defects Corrected
The following issues were corrected between release 1.0.5.1 and 1.0.6.2:
•
Fixed an issue with instability on the 8 and 24 port switches when installing
a language pack.
a language pack.