Руководство По Установке для Cisco Cisco Packet Data Gateway (PDG)

Initial System Configuration

▀ Configure the Ethernet Management Interface

▄ ASR 5500 Installation Guide

122

Configuring the Ethernet Management Interface

The procedure below describes how to configure an Ethernet management interface on the primary MIO/UMIO in
slot 5.

Important:

Repeat the procedure below to configure the second Ethernet management interface on the

MIO/UMIO in slot 5.

Step 1

Enter config to enter the configuration mode.

[local]host_name# config

Step 2

Enter context local to enter the context configuration mode. The following prompt appears:

[local]host_name(config)# context local
[local]host_name(config-ctx)#

Step 3

Enter interface interface_name to specify a name for the interface. interface_name is the name of the interface. The
interface name can be between 1 and 79 alphanumeric characters and is case sensitive. The following prompt appears as
the system enters the Ethernet Interface Configuration mode:

[local]host_name(config-ctx)# interface local01
[local]host_name(config-if-eth)#

Step 4

Configure the IP address for the interface.



For IPv4: Configure an IP address for the interface configured in the previous step by entering ip address

ipaddress subnetmask. ip_address specifies the IP address for the interface in dotted-decimal format.
subnetmask specifies the subnet mask for the interface in dotted-decimal or CIDR format.



For IPv6: Configure an IP address for the interface configured in the previous step by entering ipv6 address

ipv6address subnetmask. ipv6address specifies the IP address for the interface in colon-separated-hexadecimal
format. subnetmask specifies the subnet mask for the interface in colon-separated-hexadecimal or CDIR
format.

For example:

[local]host_name(config-if-eth)# ip address 10.0.153.100 255.255.255.248

[local]host_name(config-if-eth)# ipv6 address 2620:0:60:48::10/64

Step 5

Enter exit to exit the Ethernet interface configuration mode. The following prompt appears:

[local]host_name(config-ctx)#

Step 6

If necessary, configure a static route to point the system to a default gateway by entering the following command: { ip |
ipv6 } route gw_address interface_name. gw_address specifies the IP address of the default gateway in IPv4 dotted-
decimal format or IPv6 colon-separated-hexadecimal format). interface_name specifies the name of the interface that
was configured in Step 2. Refer to the System Administration Guide for additional information.

Step 7

Enter exit at the prompt to exit the context configuration mode. The following prompt appears:

[local]host_name(config-ctx)# exit
[local]host_name(config)#