Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands
▀ threshold 10sec-cpu-utilization
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
threshold 10sec-cpu-utilization
Configures a threshold that measures a 10 second average of cpu utilization. Its polling interval can be set down to 30
seconds.
seconds.
Product
PDSN, GGSN, HA, ASN GW
Privilege
Security Administrator, Administrator
Syntax
Default: 0
Configures the high threshold for 10 second average cpu-utilization. If the monitored CPU utilization is
greater than or equal to the specified percentage an alert is sent. Regardless of the length of the polling
interval, only one sample at the end of the polling interval is tested.
Configures the high threshold for 10 second average cpu-utilization. If the monitored CPU utilization is
greater than or equal to the specified percentage an alert is sent. Regardless of the length of the polling
interval, only one sample at the end of the polling interval is tested.
Default: 0:
This is a low watermark value that sets the alarm clearing threshold value. If not specified it is taken from the
first value.
This is a low watermark value that sets the alarm clearing threshold value. If not specified it is taken from the
first value.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to set a threshold that sends an alert when CPU utilization over a 10 second average
exceeds the limit set.
Alerts or alarms are triggered for 10-second sample of CPU utilization based on the following rules:
exceeds the limit set.
Alerts or alarms are triggered for 10-second sample of CPU utilization based on the following rules:
Enter condition: 10-second average percentage of CPU utilization ³ High Threshold
Clear condition: 10-second average percentage of CPU utilization < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
command to configure the polling interval and the
command to enable thresholding for this value.
Important:
This command is not supported on all platforms.
Example
Send an alert when the 10 second average CPU utilization reaches 45 percent by entering the following command;
Send an alert when the 10 second average CPU utilization reaches 45 percent by entering the following command;