Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
HA Service Configuration Mode Commands
▀ nat-traversal
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
nat-traversal
This command enables NAT traversal and also configures the forcing of UDP tunnels for NAT traversal.
Product
HA
Privilege
Security Administrator, Administrator
Syntax
Disables NAT traversal or disables forcing the acceptance of UDP tunnels for NAT traversal.
Reset the defaults for this command.
Default: NAT traversal disabled, force-accept disabled.
Default: NAT traversal disabled, force-accept disabled.
This keyword configures the HA to accept requests when NAT is not detected but the Force (F) bit is set in
the RRQ with the UDP Tunnel Request. By default this type of request is rejected if NAT is not detected.
the RRQ with the UDP Tunnel Request. By default this type of request is rejected if NAT is not detected.
Usage
Use this command to enable NAT traversal and enable the forcing of UDP tunnels for NAT traversal.
Example
The following command enables NAT traversal for the current HA service and forces the HA to accept UDP tunnels for
NAT traversal:
The following command enables NAT traversal for the current HA service and forces the HA to accept UDP tunnels for
NAT traversal: