Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
HNB-GW Service Configuration Mode Commands
▀ rtp port
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
rtp port
This command configures the Real Time Protocol (RTP) port range to listen from HNB while connecting to MSC/VLR
through IuCSoIP (IuCS-over-IP) interface support via an HNB-GW service. This command is used for RTP stream
management on HNB-GW.
through IuCSoIP (IuCS-over-IP) interface support via an HNB-GW service. This command is used for RTP stream
management on HNB-GW.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Syntax
Sets the RTP port range to default range from 16384 to 65535.
Specifies the port number range to be used by HNB to map the RTP streams and HNB-GW listen on these
ports while communicating with MSC/VLR through IuCS-over-IP tunnel.
ports while communicating with MSC/VLR through IuCS-over-IP tunnel.
must be an integer between 16384 through 65535 and should be less than
.
must be an integer between 16384 through 65535 and should be more than
.
Default: port 16384 through 65535
Important:
This command cannot be entered more than once. Only one range of RTP port can be configured for
one HNB-GW service.
Usage
Caution:
This command is NOT active now.
Use this command to assign the RTP port range to be used by HNB to map RTP streams and HNB-GW listen
these ports for RTP streams while communicating with MSC/VLR through IuCS-over-IP tunnel.
This command is used for RTP stream management on HNB-GW.
these ports for RTP streams while communicating with MSC/VLR through IuCS-over-IP tunnel.
This command is used for RTP stream management on HNB-GW.
Example
The following command sets the RTP port number
The following command sets the RTP port number
to
on HNB-GW to listen from HNB for RTP streams
while connecting with MSC/VLR using IuCS-over-IP tunnel.