Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
HNB-CS Network Configuration Mode Commands
▀ associate alcap-service
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
associate alcap-service
This command associates a previously defined Access Link Control Application Part (ALCAP) service with the CS
network instance for multiplexing of different users onto one AAL2 transmission path using channel IDs (CIDs). This
configuration is provided to support IuCS-over-ATM functionality
network instance for multiplexing of different users onto one AAL2 transmission path using channel IDs (CIDs). This
configuration is provided to support IuCS-over-ATM functionality
Product
HNB-GW
Privilege
Security Administrator, Administrator
Syntax
Removes the associated ALCAP service from this HNB-CS network instance configuration.
Identifies the name of the ALCAP service preconfigured in Context configuration mode to associate with an
HNB-CS network instance for multiplexing of different users onto one AAL2 transmission path using
channel IDs (CIDs).
The
HNB-CS network instance for multiplexing of different users onto one AAL2 transmission path using
channel IDs (CIDs).
The
must be a preconfigured ALCAP service.
Only one instance of this command can be configured.
Caution:
If this CLI is not configured any RAB-ASST-REQ requesting AAL2 connection setup shall be
rejected with an appropriate cause.
Specifies the name of the context in which ALCAP service is configured.
The
The
must be an existing context name in which this ALCAP service is configured.
Usage
Use this command to configure IuCS-over-ATM support. This association of ALCAP protocol service
configuration in HNB-CS network instance provides multiplexing of different users onto one AAL2
transmission path using channel IDs (CIDs).
configuration in HNB-CS network instance provides multiplexing of different users onto one AAL2
transmission path using channel IDs (CIDs).
Caution:
If this CLI is not configured any RAB-ASST-REQ message requesting AAL2 connection setup shall
be rejected with an appropriate cause.
Important:
This command must not be used more than once to configure IuCS-over-ATM support.
Example