Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
HNB-RN PLMN Configuration Mode Commands
▀ associate cs-network
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
associate cs-network
This command associates a preconfigured circuit switched (CS) network within an HNB radio network PLMN with
HNB-GW service.
HNB-GW service.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Syntax
Disassociates/removes the configured CS network with an HNB radio network PLMN configured in HNB-
GW service mode.
GW service mode.
Specifies the name of a preconfigured CS network in Global configuration mode with
command and to be associated with an HNB radio network PLMN configured in HNB-GW service mode.
To configure CS network, refer HNB-CS Configuration Mode Commands chapter.
To configure CS network, refer HNB-CS Configuration Mode Commands chapter.
This keyword defines the granularity level of circuit switch network to a location area code (LAC) level to be
associated with radio network PLMN in HNB-GW service.
associated with radio network PLMN in HNB-GW service.
must be an integer between 1 and 65535.
Usage
Use this command to associate pre-defined CS networks with a radio network PLMN in an HNB-GW
service.
The circuit switched network comprises of one or more MSCs, where CS-domain IU-connections shall be
routed. In a typical deployment HNB-GW is connected to only one MSC. However due to Iu-flex and
networks-sharing requirements, HNB-GW can be connected to more than one MSCs as well.
Another scenario when HNB-GW can be connected to multiple MSCs is when a set of HNBs should be
connected to a particular MSC based on their UTRAN location or geographical location.
This command provides configuration to have one or more MSCs such that these are used in load-shared
(IuFlex) or network-shared mode. If location based distribution of HNBs to MSCs is desired then more than
one circuit switched network configuration will be required.
This configuration allows association of a circuit switched network with a radio network PLMN and
granularity can either be at the PLMN level or at the level of a location area (LAC) in that PLMN.
To configure CS network, refer HNB-CS Configuration Mode Commands chapter.
service.
The circuit switched network comprises of one or more MSCs, where CS-domain IU-connections shall be
routed. In a typical deployment HNB-GW is connected to only one MSC. However due to Iu-flex and
networks-sharing requirements, HNB-GW can be connected to more than one MSCs as well.
Another scenario when HNB-GW can be connected to multiple MSCs is when a set of HNBs should be
connected to a particular MSC based on their UTRAN location or geographical location.
This command provides configuration to have one or more MSCs such that these are used in load-shared
(IuFlex) or network-shared mode. If location based distribution of HNBs to MSCs is desired then more than
one circuit switched network configuration will be required.
This configuration allows association of a circuit switched network with a radio network PLMN and
granularity can either be at the PLMN level or at the level of a location area (LAC) in that PLMN.
To configure CS network, refer HNB-CS Configuration Mode Commands chapter.
Example
The following command associates a CS network
The following command associates a CS network
with radio network PLMN with a granularity of LAC
: