Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
APN Configuration Mode Commands
content-filtering category ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
content-filtering category
This command enables/disables the specified pre-configured Category Policy Identifier for Category-based Content
Filtering support.
Filtering support.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Disables the previously configured category policy identifier for Content Filtering support to the APN. This is
the default setting.
the default setting.
This command applies the specified content filtering category policy ID, configured in Active Charging
Configuration mode, to this APN.
Configuration mode, to this APN.
must be a preconfigured category policy ID in Active Charging Configuration Mode.
In case category policy identifier
used here is not configured in Active Charging
Configuration Mode, all packets will be passed regardless of the categories determined for such packets.
Important:
Category Policy Id configured through this mode overrides the Category Policy id configured
through
command in Rulebase Configuration Mode of Active
Charging Service Configuration mode.
Usage
Use this command to enter the Content Filtering Policy Configuration mode and to enable or disable the
Content Filtering Category Policy ID for an APN.
Content Filtering Category Policy ID for an APN.
Important:
If Content Filtering Category Policy ID is not specified here the similar command in ACS Rulebase
Configuration Mode determines the policy.
Up to 64 different policy identifier can be defined in a Content Filtering support service.
Example
Following command enters the Content filtering Policy Configuration mode and enables the Category Policy Id
Following command enters the Content filtering Policy Configuration mode and enables the Category Policy Id
for
Content Filtering support: