Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
ASN Gateway Service Configuration Mode Commands
▀ active-relay
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
active-relay
This command enables the active relay functionality for R4 and R6 messages in ASN GW and configures the timeout
duration in seconds for R4 or R6 messages actively relayed by the ASN GW (e.g. Data Path messages).
duration in seconds for R4 or R6 messages actively relayed by the ASN GW (e.g. Data Path messages).
Product
ASN GW
Privilege
Administrator
Syntax
Sets the total timeout duration to 15 seconds to actively relayed R4 or R6 messages.
Default: 15
Specifies the maximum allowable timeout duration for the ASN GW service to actively relay the R4 or R6
messages.
Specifies the maximum allowable timeout duration for the ASN GW service to actively relay the R4 or R6
messages.
is measured in seconds and can be configured to any integer value from 5 through 65535.
Usage
Use this command to enable the active relay of R4 and R6 messages and also to configure the maximum
timeout duration for the actively relayed R4 or R6 messages by ASN GW.
By default system is pre-configured for passive relay functionality for R4 and R6 messages.
timeout duration for the actively relayed R4 or R6 messages by ASN GW.
By default system is pre-configured for passive relay functionality for R4 and R6 messages.
Example
The following command configures the timeout duration of
The following command configures the timeout duration of
seconds for actively relayed R4 or R6 messages: