Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
ASN Gateway Service Configuration Mode Commands
▀ peer-asngw
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
peer-asngw
This command provides the facility to configure the addresses of trusted non-anchor ASN GW or non-anchor ASN
PC/LR peers that a specific ASN GW service can allow R4 control and data path registration with.
PC/LR peers that a specific ASN GW service can allow R4 control and data path registration with.
Product
ASN GW
Privilege
Administrator
Syntax
Removes the configured non-anchor ASN GW or non-anchor ASN PC/LR peers from a specific ASN GW
service‘s trusted peer list.
service‘s trusted peer list.
Specifies the IP address of the non-anchor ASN GW or non-anchor ASN PC/LR peers which is added as a
trusted peer with the ASN GW service.
trusted peer with the ASN GW service.
is the IP address of the non-anchor ASN GW or non-anchor ASN PC/LR peers expressed in
IPv4 dotted decimal or IPv6 colon separated notation.
Usage
Use this command to create the trusted non-anchor ASN GW or non-anchor ASN PC/LR peers with a
specific ASN GW service to establish R4 control and data path registration.
On receipt of R4 control or data path registration request message the ASN GW service checks whether non-
anchor DPF/Authenticator ASN GW/ASN PC-LR address received in request message is in trusted peer ASN
GW/ASN PC-LR list configured with this command. If the Anchor DPF/Authenticator ASN GW/ASN PC-
LR address received in request message is not there (or not configured) in non-anchor ASN GW or non-
anchor ASN PC/LR peers list the ASN GW service sends response for request message with Failure
Indication TLV with unspecified error code.
A maximum of 32 ASN GWs or ASN PC/LRs can be configured with this command.
specific ASN GW service to establish R4 control and data path registration.
On receipt of R4 control or data path registration request message the ASN GW service checks whether non-
anchor DPF/Authenticator ASN GW/ASN PC-LR address received in request message is in trusted peer ASN
GW/ASN PC-LR list configured with this command. If the Anchor DPF/Authenticator ASN GW/ASN PC-
LR address received in request message is not there (or not configured) in non-anchor ASN GW or non-
anchor ASN PC/LR peers list the ASN GW service sends response for request message with Failure
Indication TLV with unspecified error code.
A maximum of 32 ASN GWs or ASN PC/LRs can be configured with this command.
Example
The following command adds the ASN GW with an IP address of
The following command adds the ASN GW with an IP address of
as a trusted peer within an ASN GW
service.