Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
ASN Gateway Service Configuration Mode Commands
▀ secondary-ip-hosts
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
secondary-ip-hosts
Use this command to enable or disable multiple host support behind WiMAX customer premises equipment (CPE).
Default: disabled
Default: disabled
Product
ASN GW
Privilege
Administrator
Syntax
Sets the multiple host configuration in an ASN GW service to disabled (default mode).
Default: 0 (disabled)
Specifies the maximum number of hosts allowed to connect through one primary node connection behind a
WiMAX CPE.
Specifies the maximum number of hosts allowed to connect through one primary node connection behind a
WiMAX CPE.
must be an integer from 0 through 4, where 0, the default value, disables this feature.
Usage
Use this command to enable or disable multi-IP host support in an ASN GW service behind one WiMAX
CPE through a primary airlink. If enabled, this command supports up to four hosts as an auxiliary connection.
Accounting and UDR generation for such connections are based on the primary connection with the WiMAX
CPE. To apply this facility to a subscriber, configure the
CPE through a primary airlink. If enabled, this command supports up to four hosts as an auxiliary connection.
Accounting and UDR generation for such connections are based on the primary connection with the WiMAX
CPE. To apply this facility to a subscriber, configure the
command in
the Subscriber Configuration mode.
Example
The following command enables multiple host support and instructs the ASN GW service to allow IP hosts as
auxiliary connections behind one CPE:
The following command enables multiple host support and instructs the ASN GW service to allow IP hosts as
auxiliary connections behind one CPE:
The following command disable the multiple host support and instructs the ASN GW service not to allow auxiliary
connections behind one CPE:
connections behind one CPE: