Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)

Скачать
Страница из 5213
  ACL Configuration Mode Commands 
redirect context (by IP address masking)  ▀   
Cisco ASR 5000 Series Command Line Interface Reference  ▄  
 
  OL-22947-02 
The IP address(es) form which the packet originated. 
This option is used to filter all packets from a specific IP address or a group of IP addresses. 
When specifying a group of addresses, the initial address is configured using this option. The range can then 
be configured using the 
 parameter. 
This option is used in conjunction with the 
 option to specify a group of addresses for 
which packets are to be filtered. 
The mask must be entered as a complement: 
 
Zero-bits in this parameter mean that the corresponding bits configured for the 
 
parameter must be identical. 
 
One-bits in this parameter mean that the corresponding bits configured for the 
 
parameter must be ignored. 
Important:
  The mask must contain a contiguous set of one-bits from the least significant bit (LSB). Therefore, 
allowed masks are 0, 1, 3, 7, 15, 31, 63, 127, and 255. For example, acceptable wildcards are 0.0.0.3, 0.0.0.255, and 
0.0.15.255. A wildcard of 0.0.7.15 is not acceptable since the one-bits are not contiguous. 
Usage
 
Define a rule when any packet from the IP addresses which fall into the group of addresses matching the IP 
address masking. This allows the reduction of redirect rules as it does not require a rule for each source and 
destination pair. 
Important:
  The maximum number of rules that can be configured per ACL varies depending on how the ACL is 
to be used. For more information, refer to the Engineering Rules appendix in the System Administration Guide. 
Important:
  Also note that ―redirect‖ rules are ignored for ACLs applied to specific subscribers or all subscribers 
facilitated by a specific context. 
Example 
The following command defines a rule that redirects packets to the context with the context ID of 23 and the source IP 
and wildcard of 192.168.22.0 and 0.0.0.31:  
The following sets the insertion point before the rule defined above:  
The following command sets the insertion point after the first rule defined above:  
The following deletes the first rule defined above: