Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
Exec Mode Show Commands (A-C)
▀ show cpu
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
show cpu
Displays information on system CPUs.
Product
All
Privilege
Security Administrator, Administrator, Operator, Inspector
Syntax
Specifies information for an entire card or a specific CPU is to be displayed.
: Specifies the card to display associated information.
must be a value in the
range 1 through 48 and must refer to an installed card.
: Optionally selects a specific CPU on the card of interest to display specific information.
must be a value in the range 0 through 3 and must refer to an installed CPU.
: In addition to textual CPU information display CPU utilization information in graphs.
: Output is to display all information available.
Display, in tabular format, all cards and CPUs.
Indicates the output of the command is to be piped (sent) to the command specified. A command to send
output to must be specified.
For details on the usage of
output to must be specified.
For details on the usage of
and
, refer to the Regulating a Command’s Output section of the
Command Line Interface Overview chapter.
Usage
View CPU statistics to aid in diagnosing service problems for the case of overload conditions.
Important:
This command is not supported on all platforms.
Example
The following command displays the CPU information in tabular format for all CPUs on all installed cards:
The following command displays the CPU information in tabular format for all CPUs on all installed cards:
The following command displays CPU information for card in verbose mode: