Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
Exec Mode Show Commands (D-G)
▀ show egtpc peers
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
Indicates the output of the command is to be piped (sent) to the command specified.
A command to send output to must be specified.
For details on using the
A command to send output to must be specified.
For details on using the
and
commands, refer to the Regulating a Command’s Output section of
the Command Line Interface Overview chapter.
Usage
Use this command to display information about eGTP-C peers associated with the service interface
configured on this system. The output contains the following information about the peer:
configured on this system. The output contains the following information about the peer:
Status of the peer
Echo status
Restart counter status
Peer restart counter knowledge
Service ID
Peer IP address
Current sessions
Maximum sessions
Important:
The primary command,
, when entered without additional keywords, displays
information for all peers associated with the service operating on this system.
Example
The following command returns an output for an eGTP-C S-GW egress peers associated with the service interface
configured on this system with an IP address of 1.2.3.4:
The following command returns an output for an eGTP-C S-GW egress peers associated with the service interface
configured on this system with an IP address of 1.2.3.4:
The following command returns an output for an eGTP-C MME peer associated with the service interface configured on
this system with an IP address of 1.2.3.4:
this system with an IP address of 1.2.3.4: