Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)

Скачать
Страница из 5213
  FA Service Configuration Mode Commands 
proxy-mip  ▀   
Cisco ASR 5000 Series Command Line Interface Reference  ▄  
 
  OL-22947-02 
 is the maximum number of retries and can be configured to any integer value from 1 to 
4294967295. 
Default: 75 
Configures the amount of time that must pass prior to the FA sending a Proxy Mobile IP Registration 
Renewal Request. 
 is entered as a percentage of the advertisement registration lifetime configured for the FA 
service. (Refer to the 
 command in this chapter). The time can be configured to any integer 
value from 1 to 100. 
The following equation can be used to calculate 
 = ( duration / lifetime ) * 100 
duration = The desired amount of time that can pass prior to the FA sending a Proxy Mobile IP Registration 
Renewal Request 
lifetime = The advertisement registration lifetime configured for the FA service. 
duration £ lifetime 
Default: 3 
Configure the maximum amount of time allowed by the FA for a response from the HA before re-sending a 
Proxy Mobile IP Registration Request message. 
 is measured in seconds and can be configured to any integer value from 1 to 100. 
Usage
 
The proxy-mip command and its keywords configure the FA services support for Proxy Mobile Mobile IP. 
When enabled though the session license and feature use key, the system supports Proxy Mobile IP to provide 
a mobility solution for subscribers with mobile nodes (MNs) capable of supporting only Simple IP. 
In addition to the parameters configured via this command, the HA-FA SPI(s) must also be modified to 
support Proxy Mobile IP. Refer to the fa-ha-spi command for more information. 
Example 
The following command configures the FA service to wait up to 5 seconds for an HA to respond prior to re-sending an a 
Mobile IP Registration Request message: 
If the advertisement registration lifetime configured for the FA service is 900 seconds and you want the system to send a 
Proxy Mobile IP Registration Renewal Request message after 500 seconds, then the following command must be 
executed: 
Note that 50 = (450 / 900) 100.