Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands
high-availability ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
high-availability
Configures PAC/PSC/PSC2 task failure detection speed.
Product
PDSN, GGSN, ASN GW
Privilege
Security Administrator, Administrator
Syntax
Default:
: Initiates PAC/PSC failover without performing additional checks.
: Initiates PAC/PSC failover after additional checks are performed.
Usage
Use this command to increase the fault detection speed for faster switchovers after a PAC/PSC/PSC2 task
failure.
Setting fault detection speed to aggressive will trigger PAC/PSC/PSC2 failover as soon as possible if a
potential failure is detected. Aggressive mode will reduce the duration of subscriber outages caused by a
failed PAC/PSC/PSC2 if session recovery is enabled.
Aggressive mode also bypasses most information gathering steps and logs that can be used to determine the
root cause of the failure.
In normal mode, additional checks are performed before triggering a PAC/PSC/PSC2 failover to ensure the
card has actually failed. In aggressive mode these checks are bypassed so that session recovery can start as
soon as possible. These additional checks reduce the likelihood of a false positive failure.
failure.
Setting fault detection speed to aggressive will trigger PAC/PSC/PSC2 failover as soon as possible if a
potential failure is detected. Aggressive mode will reduce the duration of subscriber outages caused by a
failed PAC/PSC/PSC2 if session recovery is enabled.
Aggressive mode also bypasses most information gathering steps and logs that can be used to determine the
root cause of the failure.
In normal mode, additional checks are performed before triggering a PAC/PSC/PSC2 failover to ensure the
card has actually failed. In aggressive mode these checks are bypassed so that session recovery can start as
soon as possible. These additional checks reduce the likelihood of a false positive failure.
Example
The following command sets the fault detection speed for PAC/PSC/PSC2/tasks to
The following command sets the fault detection speed for PAC/PSC/PSC2/tasks to
: