Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
ACS Configuration Mode Commands
fw-and-nat policy ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
fw-and-nat policy
This command enables creating/configuring/deleting a Firewall-and-NAT policy.
Important:
This command is only available in StarOS 8.1 and StarOS 9.0 and later releases. This command must
be used to configure the Policy-based Stateful Firewall and NAT features.
Product
FW, NAT
Privilege
Security Administrator, Administrator
Syntax
Deletes the specified Firewall-and-NAT policy, if previously configured, from the active charging service.
Important:
When a Firewall-and-NAT policy is deleted, for all subscribers using the policy, Stateful Firewall
and NAT processing is disabled, also ACS sessions for the subscribers are dropped. In case of session recovery, the
calls are recovered but with Stateful Firewall and NAT disabled.
calls are recovered but with Stateful Firewall and NAT disabled.
Specifies name of the Firewall-and-NAT policy.
must be an alpha and/or numeric string of 1 through 63 characters in length.
If the named Firewall-and-NAT policy does not exist, it is created and the CLI mode changes to the Firewall-
and-NAT Policy Configuration Mode, wherein the policy can be configured.
If the named Firewall-and-NAT policy already exists, the CLI mode changes to the Firewall-and-NAT Policy
Configuration Mode for that policy.
and-NAT Policy Configuration Mode, wherein the policy can be configured.
If the named Firewall-and-NAT policy already exists, the CLI mode changes to the Firewall-and-NAT Policy
Configuration Mode for that policy.
Specifies that the command must execute without prompting for confirmation.
Usage
Use this command to create/configure/delete a Firewall-and-NAT policy.
Also see the Firewall-and-NAT Policy Configuration Mode Commands chapter.
Also see the Firewall-and-NAT Policy Configuration Mode Commands chapter.
Example
The following command creates a Firewall-and-NAT policy named
The following command creates a Firewall-and-NAT policy named
, and changes to the Firewall-and-NAT
Policy Configuration Mode: