Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
IPv6 ACL Configuration Mode Commands
▀ redirect css service (for downlink, by host IP address)
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
Apply this rule definition only to packets in the downlink (from the Mobile Node) direction.
Default: packets are not logged.
Indicates all packets which match the redirect are to be logged.
Indicates all packets which match the redirect are to be logged.
Specifies that the rule definition applies to a specific host as determined by its IP address.
The IP address of the source host to filter against expressed in IPv6 colon notation.
Usage
Define a rule definition when a very specific remote host is to be blocked. In simplified networks where the
access controls need only block a few hosts, this command allows the rule definitions to be very clear and
concise.
access controls need only block a few hosts, this command allows the rule definitions to be very clear and
concise.
Important:
A maximum of 16 rule definitions can be configured per ACL. Also note that ―redirect‖ rule
definitions are ignored for ACLs applied to specific subscribers or all subscribers facilitated by a specific context.
Example
The following command defines a rule definition that redirects packets to the charging service with the name
The following command defines a rule definition that redirects packets to the charging service with the name
and a host IP address of
:
The following sets the insertion point to before the first rule definition above:
The following command sets the insertion point after the second rule definition above:
The following deletes the first rule definition above: