Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
MIPv6HA Service Configuration Mode Commands
simul-bindings ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
simul-bindings
Specifies the maximum number of ―care-of‖ addresses that can simultaneously be bound for the same user as identified
by NAI and Home address.
by NAI and Home address.
Product
PDSN, HA
Privilege
Security Administrator, Administrator
Syntax
Configures maximum number of "care of" addresses that can be simultaneously bound for the same user as
identified by their NAI and home address.
number can be configured to any integer value between 1 and 3. Default is 1.
identified by their NAI and home address.
number can be configured to any integer value between 1 and 3. Default is 1.
Usage
The chassis is shipped from the factory with the simultaneous sessions set to 1.
Per RFC 2002, the HA service creates a mobile binding record (MBR) for each subscriber session it is
facilitating. Each MBR is associated with a care-of address. As the mobile node roams, it is possible that the
session will be associated with a new care of address.
Typically, the HA service will delete an old binding and create a new one when the information in the
Registration Request changes. However, the mobile could request that the HA maintains previously stored
MBRs. This command allows you to configure the maximum number of MBRs that can be stored per
subscriber if the requested.
Per RFC 2002, the HA service creates a mobile binding record (MBR) for each subscriber session it is
facilitating. Each MBR is associated with a care-of address. As the mobile node roams, it is possible that the
session will be associated with a new care of address.
Typically, the HA service will delete an old binding and create a new one when the information in the
Registration Request changes. However, the mobile could request that the HA maintains previously stored
MBRs. This command allows you to configure the maximum number of MBRs that can be stored per
subscriber if the requested.
Example
The following command configures the service to support up to 2 addresses per subscriber:
The following command configures the service to support up to 2 addresses per subscriber: