Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
Subscriber Configuration Mode Commands
overload-disconnect ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
overload-disconnect
Sets the threshold parameter for overload disconnect.
Product
ASN GW, HA,PDIF, PDSN,PHS GWPDG/TTG
Privilege
Security Administrator, Administrator
Syntax
Sets the inactivity time threshold in seconds. This value must be from 0 to 4294967295. The default value of
zero disables this feature. If
zero disables this feature. If
for the subscriber‘s session is greater than
, the session becomes a candidate for disconnection.
Sets the connection time threshold in seconds. This value must be from 0 to 4294967295. A value of zero
disables this feature. If connect-time for the subscriber‘s session is greater than
disables this feature. If connect-time for the subscriber‘s session is greater than
, the session becomes a candidate for disconnection.
This command enables the default condition for this subscriber.
Disables the overload disconnect feature for this subscriber. This is the default condition for PDIF.
Usage
Set a subscriber‘s overload disconnect threshold in seconds, based on either inactivity or connection time.
When this threshold is exceeded during a session, the subscriber‘s session becomes a candidate for
disconnection. To set overload-disconnect policies for the entire chassis, see
When this threshold is exceeded during a session, the subscriber‘s session becomes a candidate for
disconnection. To set overload-disconnect policies for the entire chassis, see
in Global Configuration Mode Commands.
Example