Руководство По Устранению Ошибки для Cisco Cisco Tunnel Terminating Gateway (TTG)
Diameter Endpoint Configuration Mode Commands
peer ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
Specifies to send Disconnect-Peer-Request to the specified peer with the specified disconnect reason. The
disconnect cause must be an integer from 0 through 2, for one of the following:
disconnect cause must be an integer from 0 through 2, for one of the following:
REBOOTING(0)
BUSY(1)
DO_NOT_WANT_TO_TALK_TO_YOU(2)
To use Stream Control Transmission Protocol (SCTP) for this peer.
Indicates that more than one of the previous keywords can be entered within a single command.
Usage
Use this command to add a peer to the Diameter endpoint.
Example
The following command adds the peer named
The following command adds the peer named
with IP address
using port
: