Руководство По Устранению Ошибки для Cisco Cisco Tunnel Terminating Gateway (TTG)
Subscriber Configuration Mode Commands
▀ asn-policy
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
Default: enabled
This option allows all the service flows coming from HA to FA and any other packet does not matching to
any of the classifiers set for this subscriber and sent to the BS/MS over downlink flow
This option allows all the service flows coming from HA to FA and any other packet does not matching to
any of the classifiers set for this subscriber and sent to the BS/MS over downlink flow
Specifies whether the call is Auth only or not.
Enables the policy for this subscriber to allow auth-only in an ASN GW service.
Default
Disables the policy for this subscriber to allow auth-only in an ASN GW service.
Disables the policy for this subscriber to allow auth-only in an ASN GW service.
Usage
Use this command to configure subscriber policy to allow/disallow the idle mode operation or the downlink
traffic flow for a subscriber in an ASN GW service.
For authentication configuration, the ASNGW supports the Initial Network Entry (INE) for Ethernet CS calls.
The base station supports Ethernet CS traffic to the network. The INE procedure includes the Authentication
of the service flows and IP-Address allocation through DHCP. Authentication is based on the Extensible
Authentication Protocol (EAP).
This command allows MS to transition to idle mode with an ASN GW.
traffic flow for a subscriber in an ASN GW service.
For authentication configuration, the ASNGW supports the Initial Network Entry (INE) for Ethernet CS calls.
The base station supports Ethernet CS traffic to the network. The INE procedure includes the Authentication
of the service flows and IP-Address allocation through DHCP. Authentication is based on the Extensible
Authentication Protocol (EAP).
This command allows MS to transition to idle mode with an ASN GW.
Example
The following command configures the policy to allow the idle mode for an MS with an ASN GW:
The following command configures the policy to allow the idle mode for an MS with an ASN GW: