Руководство По Устранению Ошибки для Cisco Cisco Tunnel Terminating Gateway (TTG)
Service Configuration Procedures
Creating and Configuring Ethernet Interfaces and Ports ▀
Cisco ASR 5000 Series Access Service Network Gateway Administration Guide ▄
OL-22953-01
Step 19 Verify that your port configuration settings are correct by entering the following command:
slot# is the chassis slot number of the line card on which the physical port resides. slot# can be any integer value from
17 to 39, and 42 to 48. port# is the number of the port.
17 to 39, and 42 to 48. port# is the number of the port.
This command produces an output similar to that displayed below, which shows the configuration of port 1 of the line
card installed in chassis slot 17. In this example, the port is bound to an interface called rp1 configured in a context
called source.
card installed in chassis slot 17. In this example, the port is bound to an interface called rp1 configured in a context
called source.
end
Step 20 To verify that you configured your static route(s) properly, by enter the following command:
This command produces an output similar to that displayed in the following example, which shows a static route to a
gateway with an IP address of 192.168.250.1:
gateway with an IP address of 192.168.250.1:
Step 21 Save your configuration as described in Saving Your Configuration.