Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
Configuring Enhanced Charging Services
Configuring Post Processing Feature ▀
Cisco ASR 5000 Series Enhanced Charging Services Administration Guide ▄
OL-22951-01
Configuring Post Processing Feature
This section describes how to configure the Post-processing feature to enable processing of packets even if rule
matching for them has been disabled.
matching for them has been disabled.
To configure the Post-processing feature, use the following configuration:
Notes:
In the Rulebase Configuration Mode, the ruledef configured for post-processing action must have been
configured for post processing in the Ruledef Configuration mode.
If the same ruledef is required to be a charging rule in one rulebase and a post-processing rule in another
rulebase, then two separate identical ruledefs must be defined.
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
In this release, post processing with group-of-ruledefs is not supported.
In this release, delay charging with dynamic rules is not supported, hence there cannot be dynamic post-
processing rules.