Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
GGSN Service Configuration Procedures
▀ APN Configuration
▄ Cisco ASR 5000 Series Gateway GPRS Support Node Administration Guide
OL-22943-01
APN Configuration
This section provides instructions for configuring the APN templates that are used to determine how PDP contexts
should be processed. APNs are configured in system authentication contexts.
should be processed. APNs are configured in system authentication contexts.
I
MPORTANT
:
This section provides the minimum instruction set for configuring APNs in a GGSN service.
Commands that configure additional APN properties are provided in APN Configuration Mode Commands chapter of
Command Line Interface Reference.
Command Line Interface Reference.
These instructions assume that you have already configured the system level configuration as described in System
Administration Guide and GGSN service as described in the GGSN Service Configuration section of this guide.
Administration Guide and GGSN service as described in the GGSN Service Configuration section of this guide.
To configure the APN properties for a GGSN service:
Step 1
Create the APN in system context and specify the support of PDP contexts and selection mode by applying the example
configuration in the APN Creation and Configuration section.
configuration in the APN Creation and Configuration section.
Step 2
Configure the authentication and accounting parameters in APN by applying the example configuration in the
Authentication, Accounting, and GTPP Group Configuration in APN section.
Authentication, Accounting, and GTPP Group Configuration in APN section.
Step 3
Configure the IP allocation method in APN by applying the example configuration in the IP Address Allocation Method
Configuration in APN section.
Configuration in APN section.
Step 4
Optional. Configure the charging characteristics related parameters for the APN by applying the example configuration
in the Charging Characteristics Parameter Configuration in APN section.
in the Charging Characteristics Parameter Configuration in APN section.
Step 5
Optional. Configure virtual APNs by applying the example configuration in the Virtual APN Configuration section.
Step 6
Optional. Configure other optional parameters for the APN by applying the example configuration in the Other Optional
Parameter Configuration in APN section.
Parameter Configuration in APN section.
Step 7
Verify your APN configuration by following the steps in the APN Configuration Verification section.
Step 8
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
APN Creation and Configuration
Use the following example to create and configure the APNs: