Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
MME Service Configuration Procedures
▀ eGTP Service Configuration
▄ Cisco ASR 5000 Series Mobility Management Entity Administration Guide
72
OL-22987-01
Verifying eGTP Service Configuration
Step 1
Verify that your eGTP services and S11 interface were created and configured properly by entering the following
command in Exec Mode:
command in Exec Mode:
show egtp-service name
<
egtp_svc_name
>
The output of this command given below is a concise listing of eGTP service parameter settings as shown in the sample
output displayed. In this example, an eGTP service called egtp_svc was configured and you can see some parameters
configured as default.
output displayed. In this example, an eGTP service called egtp_svc was configured and you can see some parameters
configured as default.
Service name : egtp_svc
Service-Id : 2
Context : egtp_mme
Interface Type : mme
Status : STARTED
Restart Counter : 8
GTPC Retransmission Timeout : 5
GTPC Maximum Request Retransmissions : 4
GTPC Echo : Enabled
GTPC Echo Interval : 60
GTPU Retransmission Timeout : 5
GTPU Maximum Request Retransmissions : 4
GTPU Echo : Disbaled
GTP-C Bind Address : 192.20.20.2
Step 2
Verify configuration for errors by entering the following command in Exec Mode:
show configuration-errors section egtp-service
The output of this command displays the errors, if any, in eGTP service configuration.