Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
show apn
▀ show apn all
▄ Cisco ASR 5000 Series Statistics and Counters Reference
OL-22990-02
show apn all
Table 102.
show apn all
Command Output Descriptions
Field
Description
access point name (APN)
Indicates the name of the access point name (APN) for which counters are displayed.
authentication context
Name of the system context used for authentication for this APN.
pdp type
Indicates the type of PDP context. Possible types are:
IPv4
IPv6
PPP
Selection Mode
Indicates the APN selection mode applicable for this APN. Possible selection modes are:
Chosen by SGSN
Sent by MS
Subscribed
ip source violation
Indicates whether check for IPv4 source validation violations enabled or not. Possible status
are:
are:
Checked
Ignored
drop limit
Indicates the IP source-violation drop limit configured for the subscriber. The drop-limit is
the number of invalid packets that can be received from a subscriber prior to their session
being deleted. Refer to the
the number of invalid packets that can be received from a subscriber prior to their session
being deleted. Refer to the
command in the APN configuration
mode.
ip source violation no accounting
The IP source validation violations that were detected but not included in the statistics.
accounting mode
Indicates the accounting mode configured for this APN. Possible modes are:
gtpp - GTPP CDR accounting
none - No accounting
radius-diameter - RADIUS or Diameter accounting
No early PDUs
Specifies whether ―
‖ option configured in this APN or not.
If ―no-early-PDUs‖ is enabled, the chassis shall not send uplink/downlink data from/to a
MS till it receives the Acct-Rsp Start for the same from the AAA device. On receiving the
Acct-Rsp, pending PDUs are sent out.
MS till it receives the Acct-Rsp Start for the same from the AAA device. On receiving the
Acct-Rsp, pending PDUs are sent out.
no-interims
Specifies whether ―
‖ option configured in this APN or not.
If ―no-interims‖ is enabled, the chassis shall not send any interim message to the AAA
device.
device.
Bearer Control Mode
Specifies whether Bearer Control Mode is enabled in this APN or not.
max-primary-pdp-contexts
Specifies the maximum primary PDP contexts allowed in this APN.