Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
System Element Configuration Procedures
Creating and Configuring Ethernet Interfaces and Ports ▀
Cisco ASR 5000 Series System Administration Guide ▄
OL-22969-02
Option: In the interface config mode, add the
command, to
configure the interface for switchover to the port on the redundant line card if connectivity to a specified ip
address is lost. This can be in IPv4 or IPv6 format.
address is lost. This can be in IPv4 or IPv6 format.
Configuring a Port and Binding It to an Interface
Use the following example configuration to configure and assign a port to an interface:
Notes:
For
, use the actual chassis slot in which the line card is installed. This could be any
number from 17 to 23, or 26 to 39, or 42 to 48.
Option: In the Ethernet Port configuration mode, add the preferred slot slot# command if LC port redundancy
was enabled at the card level and you want to specific a port preference.
Option: In the Ethernet Port configuration mode, configure the port speed, if needed, by entering the
command. Refer to the Command Line Interface Reference for a complete explanation of this command.
Binding associates the port and all of its settings to the interface.
Configuring a Static Route for an Interface
Use the following example to configure a static route for an interface:
Notes:
and
are the IP address and subnet mask of the target network.
is the IP address of the default gateway or next-hop route.
To configure a route to the gateway router, use 0.0.0.0 for the network and mask variables.