Техническая Инструкция для Cisco Cisco Nexus 5010 Switch
UCS L2 Multicast with Nexus 5000 and 1000V
Series Switches Configuration Example
Series Switches Configuration Example
Document ID: 117360
Contributed by Vishal Mehta, Cisco TAC Engineer.
Jan 27, 2014
Jan 27, 2014
Contents
Introduction
Prerequisites
Requirements
Components Used
Background Information
Configure
Network Setup
N5k IGMP Querier Configuration
UCS IGMP Querier Configuration
Verify
Verification on the N1kV
Verification on the UCS
Verification on the N5k
Troubleshoot
Prerequisites
Requirements
Components Used
Background Information
Configure
Network Setup
N5k IGMP Querier Configuration
UCS IGMP Querier Configuration
Verify
Verification on the N1kV
Verification on the UCS
Verification on the N5k
Troubleshoot
Introduction
This document describes how to configure and troubleshoot Layer 2 (L2) multicast for Virtual Machines
(VMs) upon setup of the Cisco Unified Computing System (UCS), Cisco Nexus 1000V Series switches
(N1kV), and Cisco Nexus 5000 Series switches (N5k).
(VMs) upon setup of the Cisco Unified Computing System (UCS), Cisco Nexus 1000V Series switches
(N1kV), and Cisco Nexus 5000 Series switches (N5k).
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Basics of Multicast
•
Cisco UCS
•
N1kV
•
N5k
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco Nexus 5020 Series Switch Version 5.0(3)N2(2a)
•
Cisco UCS Version 2.1(1d)
•
Cisco UCS B200 M3 Blade Server with Cisco Virtual Interface Card (VIC) 1240
•
vSphere 5.1 (ESXi and vCenter)
•