Техническая Инструкция для Cisco Cisco Nexus 5010 Switch
TACACS+ in Nexus 4005I Configuration Example
Document ID: 112006
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configurations
Step−by−Step Instructions
Prerequisites
Requirements
Components Used
Conventions
Configurations
Step−by−Step Instructions
TACACS+ CLI Configuration
Verify
Troubleshoot
Related Information
Verify
Troubleshoot
Related Information
Introduction
This document describes how to configure Terminal Access Controller Access Control System (TACACS+)
in a Nexus 4000 series switch. The TACACS+ authentication varies slightly in the Nexus 4000 series than a
Cisco Catalyst Switch.
in a Nexus 4000 series switch. The TACACS+ authentication varies slightly in the Nexus 4000 series than a
Cisco Catalyst Switch.
Prerequisites
Requirements
Cisco recommends that you have knowledge of this topic: Cisco Nexus 7000 Series NX−OS Fundamentals
Commands.
Commands.
Components Used
The information in this document is based on these software and hardware versions:
Cisco Nexus 4005I Switch
•
Cisco Secure Access Control Server (ACS) 5.x
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to the Cisco Technical Tips Conventions for information on document conventions.
Configurations
The configuration example in this section describes how to configure a Nexus 4005I switch and a TACACS+
server.
server.