Техническая Инструкция для Cisco Cisco Nexus 5010 Switch
Nexus 5000 Series Switch ERSPAN Configuration
Example
Example
Document ID: 113501
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
Configurations
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
Configurations
Verify
Troubleshoot
Related Information
Introduction
This document describes how to configure an encapsulated remote switched port analyzer (ERSPAN) session
on a Nexus 5000 Series Switch that transports mirrored traffic over an IP network, which provides remote
monitoring across your network.
on a Nexus 5000 Series Switch that transports mirrored traffic over an IP network, which provides remote
monitoring across your network.
Prerequisites
Requirements
Ensure that you meet these requirements before you attempt this configuration:
Have basic knowledge of configuration on Nexus 5000 Series Switches
•
Have basic knowledge of configuration on Nexus 7000 Series Switches
•
Have basic knowledge of ERSPAN
•
Components Used
The information in this document is based on these software and hardware versions:
Nexus 5000 Switch: Cisco Nexus 5010 Series Switch on Cisco NX−OS Software Release
5.1(3)N1(1) or later
5.1(3)N1(1) or later
•
Nexus 7000 Switch: Cisco Nexus 7018 Series Switch on Cisco NX−OS Software Release 5.1(3) or
later
later
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.