Техническая Инструкция для Cisco Cisco Nexus 5010 Switch
Nexus 5000 NPIV FCoE with FCoE NPV Attached
UCS Configuration Example
UCS Configuration Example
Document ID: 116248
Contributed by Jim Hicks and Shelley Bhalla, Cisco TAC Engineers.
May 01, 2014
May 01, 2014
Contents
Introduction
Prerequisites
Requirements
Components Used
Configure
Network Diagram
Configure the UCS
Configure the Nexus 5000 for FCoE and NPIV
Verify
Zoning Example (on the Nexus 5500s)
Troubleshoot
Prerequisites
Requirements
Components Used
Configure
Network Diagram
Configure the UCS
Configure the Nexus 5000 for FCoE and NPIV
Verify
Zoning Example (on the Nexus 5500s)
Troubleshoot
Introduction
This document describes how to configure N_Port ID Virtualization (NPIV) or N_Port Virtualization (NPV)
with Fibre Channel over Ethernet (FCoE) between the Cisco Unified Computing System (UCS) and a Nexus
5000 switch.
with Fibre Channel over Ethernet (FCoE) between the Cisco Unified Computing System (UCS) and a Nexus
5000 switch.
Prerequisites
Requirements
The information in this document is based on these software and hardware versions:
UCS 5108
•
UCS 61xx/62xx
•
Nexus 5548UPor 5596UP
•
Components Used
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Configure
Network Diagram