Листовка для Cisco Cisco Aironet 340 Access Point-RP-TNC

If the base station is configured to use the 

optional built-in telephone modem, follow 

these steps:

Connect the end of the telephone cable 

with a ferrite bead (small cylinder) to 

the RJ-11 TELCO connector on the 

back of the base station.

Connect the other end of the cable to 

the telephone wall connector.

The base station does not have an on/off switch. Power is applied when the power adapter is 

plugged into the unit and connected to the wall outlet.

Follow these steps to connect the power adapter to the base station:

Connect the power adapter to a suitable power receptacle. 

Connect the power connector to the back of the base station.

The base station begins the power-on self-test (POST).

The base station begins the power-on self-test (POST) when power is supplied. LEDs show the 

progress of the test. The LEDs appear red, amber, and green to indicate the status of the POST. 

When the unit is powered on for the first time or if it has been reset to all default parameters, 

the indicators display the following sequence:

•

The Radio LED blinks several times.

•

The Status LED continuously flashes an 

amber color at a fast rate, indicating that 

the base station is set to factory defaults 

and is waiting for a wireless device to 

communicate configuration settings to 

it.

45998

ETHERNET

TELCO

5VDC

Telephone

cable

Telephone

jack

S

Network/Modem

Status

Radio

49717