Техническая Инструкция для Cisco Cisco Identity Services Engine Software
ISE Policies Based on SSID Configuration
Examples
Examples
Document ID: 115734
Contributed by Jesse Dubois, Cisco TAC Engineer.
Jul 02, 2014
Jul 02, 2014
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Configurations
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Conventions
Configure
Configurations
Verify
Troubleshoot
Related Information
Introduction
This document describes how to configure authorization policies in Cisco Identity Services Engine (ISE) to
distinguish between different service set identifiers (SSIDs). It is very common for an organization to have
multiple SSIDs in their wireless network for various purposes. One of the most common purposes is to have a
corporate SSID for employees and a guest SSID for visitors to the organization.
distinguish between different service set identifiers (SSIDs). It is very common for an organization to have
multiple SSIDs in their wireless network for various purposes. One of the most common purposes is to have a
corporate SSID for employees and a guest SSID for visitors to the organization.
This guide assumes that:
The Wireless LAN Controller (WLC) is set up and works for all SSIDs involved.
1.
Authentication works on all SSIDs involved against ISE.
2.
Other Documents in this Series
Central Web Authentication with a Switch and Identity Services Engine Configuration Example
•
Central Web Authentication on the WLC and ISE Configuration Example
•
ISE Guest Accounts for RADIUS/802.1x Authentication Configuration Example
•
VPN Inline Posture using iPEP ISE and ASA
•
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these software and hardware versions:
Wireless LAN Controller Release 7.3.101.0
•
Identity Services Engine Release 1.1.2.145
•