Техническая Инструкция для Cisco Cisco Identity Services Engine Software
ISE Administrative Portal Access with AD
Credentials Configuration Example
Credentials Configuration Example
Document ID: 116503
Contributed by Jatin Katyal, Cisco TAC Engineer.
Sep 30, 2013
Contents
Introduction
Prerequisites
Componenets Used
Configure
Join ISE to AD
Select Directory Groups
Enable Administrative Access for AD
Configure the Admin Group to AD Group Mapping
Set RBAC Permissions for the Admin Group
Access ISE with AD Credentials
Verify
Troubleshoot
Related Information
Prerequisites
Componenets Used
Configure
Join ISE to AD
Select Directory Groups
Enable Administrative Access for AD
Configure the Admin Group to AD Group Mapping
Set RBAC Permissions for the Admin Group
Access ISE with AD Credentials
Verify
Troubleshoot
Related Information
Introduction
This document describes a configuration example for the use of Microsoft Active Directory (AD) as an
external identity store for administrative access to the Cisco Identity Services Engine (ISE) management GUI.
external identity store for administrative access to the Cisco Identity Services Engine (ISE) management GUI.
Prerequisites
Cisco recommends that you have knowledge of these topics:
Configuration of Cisco ISE Versions 1.1.x or Later
•
Microsoft AD
•
Componenets Used
The information in this document is based on these software and hardware versions:
Cisco ISE Version 1.1.x
•
Windows Server 2008 Release 2
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.